Utax CD 1015 Servisní příručka stáhnout pdf (Strana 224)

2AV/X

1-6-43

1-6

1-6-5 Drum section

(1) Detaching and refitting the drum

Follow the procedure below to replace the drum.

Cautions:

• Avoid direct sunlight or strong light when detaching and fitting the drum.

• Hold the drum at the ends and never touch the drum surface.

• After removing the drum, keep it in the drum case or storage bag to protect the surface from light.

Procedure

1. Remove the image formation unit (see page

1-6-40).

2. Remove the two screws holding the transfer

right guide and then the guide.

3. Remove the screw holding each of the three

drum separation claw assemblies and then

the assemblies.

Figure 1-6-57

4. Pull the drum shaft out and replace the drum.

• Check the letter indicating the drum type (G,

H or J) printed on the new drum flange.

• When fitting the drum, orient it correctly so

that the gear is positioned at the machine

rear.

• When fitting the drum shaft, insert it fully.

Figure 1-6-58

5. Remove the front image formation unit cover.

Rub the contacting surfaces of the drum shaft

and drum drive grounding plate with a cloth

and then apply the GE-334C conductive

grease (P/N A0199040) to the contacting

surfaces of the grounding plate. Refit the

removed parts.

6. After replacing the drum, run maintenance

items below.

• U109 “Setting the drum type “ (set to the

drum type printed on the new drum flange)

• U110 “Checking/clearing the drum

count”(clear the drum count)

• U111 “Checking/clearing the drum drive

time” (clear the value)

Figure 1-6-59

Drum separation claw assemblies

Transfer right guide

Drum

Drum shaft

Drum drive grounding plate

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 295 296

Komentáře k této Příručce

Žádné komentáře

Utax CD 1015 Servisní příručka Strana 224

Komentáře k této Příručce

Související produkty a manuály pro Kopírky Utax CD 1015